Installing And Activating The Clearyl Cartridge; Replacing The Clearyl Cartridge; Replacing Clearyl Water Cartridge - Jura Capresso Impressa F7 Operating Instructions And Warranty

16a. INSTALLING & ACTIVATING THE CLEARYL WATER
CARTRIDGE
Important: Never install the cartridge before or during
"Preparing Machine For The First Time."
• Make sure the water tank is empty.
• Remove cartridge from its bag and rinse cartridge under water.
• Open water container lid and pull up the holder for the
cartridge (Fig.9).
• Insert the cartridge with its tapered end down. Make sure it
fits securely over the white mesh piece inside the water
container. Push down gently (Fig.10).
• Close the holder for the cartridge so that it engages in the
water tank (Fig.11).
• Fill the water tank with fresh cold water and replace.
You must activate the cartridge as follows:
1. Push and hold the P button (Fig. 3e).
2. Push the Dial and the display shows
3. Turn the Dial until the display shows
4. Push Dial confirm. The display shows
5. Place a 20 oz. container underneath the frother.
6. Turn the Steam/Water Selector to the water symbol.
FILTER RINSING. For the next 90 seconds the machine will
push water through the filter and through the frother. Do not
interrupt this process. This activates the filter.
The machine will stop automatically.
7. CLOSE TAP. Turn the Water/Steam Dial back to the cup symbol.
HEATING. READY.
Please note: As long as the filter is activated, the water
hardness setting is automatically turned off.
16b. REPLACING THE CLEARYL WATER CARTRIDGE
The filter is monitored automatically. After approx. 75 liters of
water (~2,500 oz.), the filter loses its effect. The display changes
from
coffee, but we recommend replacing the filter within one week!
Attention: The filter should be changed every 3 months if you
use less than 75 liters of water. In this case, no message will
appear in the display.
Important: Once the filter has lost its calcium suppressing
abilities, calcium will build up inside the machine. Since the
Water Hardness Selector is off, the machine will not remind you
when to decalcify. This could clog and ruin your machine.
• Remove the old filter. The cartridge is environmentally friendly.
• Make sure the water tank is empty.
FILTER – • Remove the new cartridge from its bag.
NO • Open the water container lid and pull up the holder for the
YES
INSERT / OPEN TAP • Insert the cartridge with its tapered end down. Make sure it
• Close the holder for the cartridge so that it engages in the
• Fill the water tank with fresh cold water and replace.
1. Turn machine off. Push and hold the Rinse Button until the
2. Place a 20 oz. container underneath the frother.
3. Turn the Steam/Water Selector to the water symbol.
16.
READY to CHG FILTER /
Dispose it with your regular household trash.
cartridge (Fig. 9).
fits securely over the white mesh piece inside the water
container. Push down gently (Fig.10).
water tank (Fig.11).
display shows CHG FILTER / OPEN
FILTER RINSING.
For the next 90 seconds the machine will push water through
READY. You can still make
TAP.