Table of Contents
Advertisement
CLASS C MOTORHOME
Slideout override
Do not work on your system unless the battery is disconnected. Failure to
comply could result in death or serious injury.
Locate and remove the access panel for the slideout motor
1.
From the rear of the motor, rotate the brake release lever counter-clockwise
1/8 turn. This will release the brake that locks the slideout in place.
2.
Disconnect one slideout motor wire near the motor.
3.
The slideout is now free to move. Locate the access panel either at the front
or rear of the slideout rail. Remove the access panel for the manual slideout
shaft.
4.
Use a 3/4 socket and ratchet on the hex head located on either end of the
drive shaft and turn the shaft until the slideout is in the position you desire.
When the slideout is fully extended (or retracted), put pressure on the wrench
to ensure a tight seal, then return the brake release lever to its normal
downward position. This will ensure that the slideout is locked into a sealed
.
position
When the slideout motor brake is released, the slideout will not lock into
place, and therefore it will not be sealed from the outdoors! When the
slideout has been retracted, return the brake release lever to its downward
position in order to seal and lock the slideout.
SECTION 5 – SLIDEOUT SYSTEMS
WARNING
Fig. 5.5 Main room slideout motor
CAUTION
.
5-3
Advertisement
Table of Contents
