Yamaha YZ250T1 Owner's Service Manual page 203

FRONT FORK
26. Install:
9 Push rod 1
9 Copper washer 2
9 Adjuster 3
To damper assembly 4.
NOTE:
9While compressing the inner tube 5, set the
cap bolt ring wrench 7 between the inner tube
and locknut 6.
9Fully finger tighten the adjuster onto the
damper assembly.
Cap bolt ring wrench:
YM-01501/90890-01501
27. Inspect:
9 Gap a between adjuster 1 and locknut 2.
Gap a between adjuster and locknut
0.5 ~1.0mm (0.02~0.04 in)
Out of specification¡ Retighten and read-
just the locknut.
NOTE:
If the adjuster is installed out of specification,
proper damping force cannot be obtained.
28. Tighten:
9 Adjuster (locknut) 1
NOTE:
Hold the locknut 2 and tighten the adjuster with
specified torque.
29. Install:
9 Adjuster 1
To inner tube.
30. Fill:
9 Front fork oil 1
From outer tube top.
Recommended oil:
Suspension oil "S1"
Standard oil amount:
245 cm
Extent of adjustment:
200 ~300 cm
6.76~10.1 US oz)
5-38
CHAS
29 Nm (2.9 m•kg, 21 ft•lb)
55 Nm (5.5 m•kg, 40 ft•lb)
3 (8.62 Imp oz, 8.28 US oz)
3 (7.04~10.6 Imp oz,