White W/Black Trace Wire: Positive Output To Siren; Black Wire: Chassis Ground; Yelow Wire: + 12 Vdc Ignition Source; Dark Green Wire/Brown Wire/Purple Wire/Orange Wire - Prestige APS-25E Installation Manual

CAUTION: Connecting the dark blue wire to the high current switched output of trunk release circuits or some
remote starter trigger inputs, will damage the control module.
Connect the dark blue wire to terminal 86 of the MRLY accessory relay (or equivalent 30 A automotive relay) and wire
the remaining relay contacts to perform the selected function of channel 2.
WHITE w/ BLACK TRACE WIRE: POSITIVE OUTPUT TO SIREN
Route this wire through a rubber grommet in the firewall to the siren location. Connect the white/black wire to the positive
wire of the siren. Secure the black ground wire of the siren to chassis ground.
RED/WHITE 5A FUSED WIRE - (VOLTAGE SENSING): + 12 VDC CONSTANT BATTERY SOURCE
Power supply for the control module.

BLACK WIRE: CHASSIS GROUND

Connect this wire to a solid, metal part of the vehicle's chassis. Do not confuse this wire with the thin black antenna
wire that exits the control module independently.
YELLOW WIRE: + 12 VDC IGNITION SOURCE
Connect this wire to a source that supplies 12 VDC when the ignition key is in the ON and CRANK positions and off
when the key is in the OFF position.
DARK GREEN WIRE: (-) INSTANT TRIGGER
This is an instant on ground trigger wire. It must be connected to the optional previously installed hood and trunk pin
switches if used.
BROWN WIRE: - DOOR TRIGGER
If the vehicle's door courtesy light switches have a - ground output when the door is opened ( GM and most Imports )
you must connect this wire to the negative output from one of the door switches. In most cases, the brown wire will only
need to be connected to one door switch, no matter how many doors the vehicle has.
WARNING: Do not use the brown wire if the vehicle has + 12 Volt output type door switches.
(see PURPLE WIRE)
NOTE: For vehicles with interior delay lighting see programming under title "Completing The Installation".
PURPLE WIRE: + DOOR TRIGGER
If the vehicle's door courtesy light switches have a + 12 volt output when the door is opened ( most Fords and some
Imports), you must connect this wire to the positive output from one of the door switches. In most cases, the purple wire
will only need to be connected to one door switch, no matter how many doors the vehicle has.
WARNING: Do not use the purple wire if the vehicle has ground output type door switches.
(see BROWN WIRE)
NOTE: For vehicles with interior delay lighting see programming under title "Completing The Installation".
ORANGE WIRE: GROUND OUTPUT WHEN ARMED
This wire is provided to control the starter cut relay. Connect the orange wire to terminal 86 of the relay and wire the
remaining relay contacts as shown in the wiring diagram.
IMPORTANT: We do not recommend using this relay to interrupt the ignition wire. Only connect this relay to
the low current starter solenoid feed wire, as indicated on the wiring diagram.
Page 5
128-9322
5/8