Table of Contents
Advertisement
Table 1 describes the BX600 system management blade LEDs:
Table 1
Management Blade LED Descriptions
LED
Description
Ethernet port
Green: On shows link is up; blinking shows power is on.
Amber: On shows LAN is active; blinking shows power is on.
Master (green)
On: The management blade is the master, responsible for managing the entire
system.
Off: The management blade is a slave—a standby or backup of the master
management blade.
Blinking: The management blade is in special mode.
Failure (amber)
On: If only one management blade is installed, it has failed.
Off: This management blade is operating normally.
Blinking: The management blade is running in power-on mode, that is, generating
a heartbeat for the master/slave selection.
Note
For more information about the master and failure management blade LEDs or the advanced
KVM management blade, see the PRIMERGY BX600 Basic Unit Operating Manual.
Consider these requirements before you install your blade switch:
• The NET1 and NET2 slots are a pair. If the NET2 slot is used, the I/O blade in the NET2 slot must
be the same type as the one in the NET1 slot.
• The NET3 and NET4 slots are a pair. If the NET4 slot is used, the I/O blade in the NET4 slot must
be the same type as the one in the NET3 slot.
• If the blade switch is installed in the NET3 and NET4 slots, an Ethernet I/O module (daughter
card) must be installed on the BX600 server.
For information about requirements for installing blades in the BX600 system or the components of
the BX600 system, see the PRIMERGY BX600 Basic Unit Operating Manual.
7
Advertisement
Table of Contents
