Nstalling The; Fixing The Installation Plate; Purging The Indoor Unit - Samsung AQV09F Series Installation Manual

Fixing the Installation Plate

Before fixing the installation plate to the wall or window frame, you must
determine the position of the 65mm hole through which the cable, pipe and
hose pass to connect the indoor unit to the outdoor unit.
When facing the wall, the pipe and cable can be connected from the:
Right

 Left
 Underside (right)
 Rear (right or left)
1
Determine the position of the pipe and drain hose hole as seen in the picture
and drill the hole with an inner diameter of 65mm so that it slants slightly
downwards.
2
If you fix the indoor unit to a...
Wall
Window frame
3 Fix the installation plate to the wall giving attention to the weight of the
indoor unit.
 If you mount the plate to a concrete wall with anchor bolts, the anchor
bolts must not project more than 20mm.
4 Determine the positions of the wooden uprights to be attached to the
window frame.
5 Attach the wooden uprights to the window frame giving attention to the
weight of the indoor unit.
6 Attach the installation plate to the wooden uprights using tapping screws as
seen in the picture.

Purging the Indoor Unit

The indoor unit is supplied with inert gas (nitrogen).
Before installing the unit, check if nitrogen gas flow out of indoor unit.
If this one isn't true, DO NOT INSTALL THE UNIT since leakage could be inside
the indoor unit.
Unscrew the caps at the end of each pipe.
Result: All inert gas exhausts from the indoor unit.
 To prevent dirt or foreign substances from getting into the pipes during
installation, do NOT remove the caps completely until you are ready to
connect the pipes.
08'FORTE_VIVACE_Inv_IM_28492A£¨4£©_E.indd 9
Follow step(s)...
3.
4 to 6.
I A

NSTALLING THE

IR CONDTIONER
(Unit : mm) 09/12
Pipe hole
(Ø65mm)
120 68
(Unit : mm)
18/24
Pipe hole
(Ø65mm)
140 68
9
E-
2007-12-6 9:32:38