Table of Contents
Advertisement
GRILL OPERATION
GRILLING
Note: Be sure to remove cooking grates before lighting charcoal.
1. Fill charcoal grate with 2lbs (0.91kgs) of charcoal briquets. Stack briquets in a pyramid.
3. Add lighter fl uid following directions on fl uid container. Before lighting, place lighter fl uid at least
25 ft (8m) away from unit. Do not lean into unit when lighting charcoal. Light charcoal. LEAVE
LID OPEN.
4. In about 15 minutes, fl ames will die out and briquets will begin to ash over. Once the briquets are
completely ashed over, spread briquets in a single layer.
5. With protective gloves on, carefully place cooking grates onto grill.
6. Place food on grill.
• Never use gasoline to light charcoal.
• Overfi lling charcoal grate can cause serious injury and damage the unit.
• Never add additional lighter fl uid once charcoal has ignited.
• Hot coals should not be left unattended.
• Unit is hot. Use protective gloves and long, sturdy cooking utensils.
GRILLING IN FIREBOX
For fi rebox use, follow Steps 1-6 above in fi rebox.
SMOKING
1. Pre-soak wood chips in water for at least 30 minutes.
2. Follow Steps 1-4 above to light charcoal in fi rebox.
3. Make sure briquets are ashed over. With protective gloves on, carefully place 1-2 cups (0.24l-0.56l)
of wood chips on top of charcoal. Never use more than 2 cups (0.56l) of wood chips at a time.
4. Close fi rebox lid and open air damper 1in - 2in (2.54cm-5.08cm).
5. Place food on cooking grate in grill.
6. Check wood chips periodically to see if wood has burned down. Add more wood chips as needed.
• Wood chips must be used in order to produce smoke and create the smoke fl avor.
• When lid is opened, sometimes a fl are up may occur. Should wood chips fl are up
immediately close lid, wait for wood chips to burn down then open lid again.
• Do not leave old wood or charcoal ashes in the fi rebox. Unit should be cleaned out prior to
each use to prevent ash build-up.
17
B
9
9
I
J
13
STEP 3
Attach leg bracket w/ firebox mount
(8b) to right short legs (9) as shown
using phillips head screws (C) and
hex flange nuts (B).
8b
Repeat step 3 on opposite side.
Do not fully tighten screws at this
time.
C
STEP 4
Insert axle (12) through holes on
short right legs (9). Slide wheel (13)
onto axle and secure using cotter clip
(I). Snap axle cap (J) onto end of
wheel assembly as shown.
Repeat step on opposite side for
remaining wheel.
Do not fully tighten screws at this
time.
12
6
Advertisement
Table of Contents
