Care And Maintenance - Everstar MPK-10CR Use & Care Manual

Care and Maintenance

!
CAUTION
Before cleaning or servicing this
unit, it is recommended that the
unit be disconnected from any
electrical supply outlet
1) Do Not use gasoline, benzene, thinner or any
other chemicals to clean this unit, as these
substances may cause damage to the finish
and deformation of plastic parts.
2) Never attempt to clean the unit by pouring
water directly over any of the surface areas, as
this will cause deterioration of electrical
components and wiring insulation.
Removal and Cleaning of the Air Filter
If the air filter becomes clogged with dust/dirt, the
air flow will be restricted and this will reduce
efficiency. The air filter should be cleaned every
two (2) weeks. More frequent cleaning may be
necessary depending upon indoor air quality.
1) To remove the air filter, grasp the air filter tab.
2) Pull the filter "out" then "up". Fig. 23.
3) Dust/Dirt clogged in the filter can be removed
by vacuum cleaning the soiled areas.
4) The filter can also be washed in lukewarm
soapy water while rubbing it lightly with a
brush. A mild detergent (dishwashing soap)
is recommended.
5) Rinse the filter well using clean water. Allow
time to dry before reinstalling into the unit.
6) Replace the air filter.
7) Replacement air filters are available through
the Customer Service Parts Department.
!
CAUTION
Never operate the unit without the
air filter in place as this may result
in damage to the unit.
!
!
14
Air Filter
Tab
Fig.23