Front View; Band Button - Pioneer F-208 Service Manual

- RF ATT button
Set this button to on when receiving strong FM signals
(nearby stations) to reduce sound distortion (RF ATT
indicator lights).
Normally, this button should be set to off.
This button does not affect AM reception.
NOTE:
This button's status is preset for each station in station
memory.
= MPX (multiplex) MODE button
Mode changes as follows each time this button is
pressed.
AUTO MONO
This button does not affect AM reception.
AUTO:
"AUTO"is not displayed.
Normally leave in this mode for reception. When a stereo
FM broadcast is received, it will be automatically
reproduced in stereo sound and the STEREO indicator
lights up.
MONO:
MONO indicator lights up.
To receive stereo broadcasts in monaural.
If there is too much noise during stereo reception of a
weak signal, you can reduce the level of noise by
switching to MONO.
NOTES:
¶ This button's status is preset for each station in station
memory.
¶ When the signal level is too weak for reception, sound
output is automatically muted. If sound is muted when
the selected mode is AUTO, switching to MONO lets
you hear the broadcast.

~ BAND button

The button is used to select either FM or AM reception.
! STATION CALL buttons
Use these buttons to preset stations and to receive the
already preset stations.
These are also used when performing direct access
tuning.

7 Front View

F-208
19