Using The Washing Machine; Load The Laundry; Measure Out The Detergent; Measure Out The Fabric Softener - John Lewis JLWM1604 Instruction Manual

Using the washing machine

Before the first wash, we recommend that you run a
cotton cycle at 90°C, without any laundry in the
machine, to remove any manufacturing residue from
the drum and tub. Pour 1/2 a measure of detergent
into the dispenser drawer and start the machine.
WASHING 7 KG OF WHITE COTTON AT 90°C
Suppose you have 7 kg of laundry to wash. It is white
cotton and is suitable for high temperature washing.

1.Load the laundry

Open the door. Place the laundry in the drum, one
item at a time, shaking them out as much as possible.
Close the door.

2.Measure out the detergent

Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required and pour it into
the main wash compartment
If you wish to carry out the prewash, a soak programme
or a stain phase, pour detergent or stain remover into
the appropriate compartment marked
Important!
Do not use normal detergent for the "Stain" option,
always use a STAIN remover.
.
.
17

3.Measure out the fabric softener

If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
Close the drawer gently.

4. Switch the machine on

Turn the selector dial to any programme to switch the
machine on. The Start/Pause light starts to flash and
the display shows the duration of the selected
programme.
To switch the appliance off turn it to "Off".
5. Select the desired
programme/temperature
Turn the selector dial to the desired position (Cottons
90° in this case).
The display will show the duration of the selected
programme, calculated on the basis of the maximum
load for each type of fabric. The Start/Pause button
light will start flashing.
If your laundry needs a soak time, turn the programme
selector dial to "Soak" and then, before starting a
washing cycle, drain the water as described in the
"Soak" paragraph.