Using Hold And Resume - Cisco 7965G User Manual

Using Hold and Resume

You can hold and resume calls. When you put a call on hold, the Hold icon
caller ID and the corresponding line button flashes green
If the Hold Reversion feature is enabled for your phone, a call that you put on hold reverts back to
ringing after a certain period of time. The 'reverting' calls remains on hold until you resume them.
Your phone indicates the presence of a reverting call by:
• Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).
• Briefly displaying a "Hold Reversion" message in the status bar at the bottom of the phone screen.
• Displaying the animated Hold Reversion icon
• Displaying a flashing amber line button
If you want to...
Put a call on hold
Remove a call from
hold on the current line
Remove a call from
hold on a different line
Tips
• Engaging the Hold feature typically generates music or a beeping tone.
• If you receive an alert for an incoming call and a reverting call at the same time, by default your
phone will shift the focus of the phone screen to display the incoming call. Your system
administrator can change this focus priority setting.
• If you use a shared line, Hold Reversion rings only on the phone that put the call on hold, not on
the other phones that share the line.
• You system administrator determines the duration between Hold Reversion alerts.
Cisco Unified IP Phone 7965G and 7945G for Cisco Unified Communications Manager 6.0 (SCCP and SIP)
Then...
1. Make sure the appropriate call is highlighted.
2. Press Hold.
1. Make sure the appropriate call is highlighted.
2. Press Resume.
1. Press the appropriate line button:
cause a held call to resume automatically:
• If there is a reverting call on the line, that call will resume.
• If there is more than one reverting call on the line, the oldest
reverting call will resume.
• If a non-reverting held call is the only call on the line, it will
resume.
2. If necessary, scroll to the appropriate call and press Resume.
.
next to the caller ID for the held call .
(depending on the line state).
or
appears next to the
(flashing). Doing so might
23