External 3.5" Device Installation; External 5.25" Device Installation; Cable Organizer; Connecting The Front I/O Ports - Antec SONATA IV User Manual

5. Connect the appropriate data and power cables from the device to the motherboard.
2.6

External 5.25" Device Installation

There are three external 5.25" drive bays.
1. Carefully remove the plastic cover and metal
plate covering the drive bay.
2. Make sure the clip on the end of the drive
rail is angled away from the device and
facing forward. Mount a plastic drive rail on each side of the 5.25" device.
3. Slide the device into the drive bay until you hear a click.
4. Connect the appropriate data and power cables from the device to the motherboard.
2.7

Cable Organizer

Instead of running all the power cables into the motherboard compartment, the cables can be
organized between the motherboard and right side panel.
1. Remove both side panels.
2. Choose the cables you would like to hide or pass through the organizer behind the
motherboard tray.
3. Run the cables to the organizer and use the cable ties to hold them in place.

Connecting the Front I/O Ports

3.1

USB 2.0 Ports

Connect the front I/O panel USB cable to the USB header pin on your motherboard. Check the
motherboard manual to ensure that it matches the table below:
1
9 10
2
Pin Signal Names
1
USB Power 1
3
Negative Signal 1
5
Positive Signal 1
7
Ground 1
9
Key (No Connection)
Pin Signal Names
2
USB Power 2
4
Negative Signal 2
7
6 Positive Signal 2
8
Ground 2
3
10
Empty Pin
5
4 Negatives Signal 2
6 Positives S