Table of Contents
Advertisement
Stop the engine using the following steps:
1. Disconnect all loads to the generator.
2. Turn engine key switch to OFF position.
3. The fuel lock-off solenoid automatically stops the flow of LP or NG to the engine.
4. Remove key from starter to prevent accidental starting of engine.
When you are finished using the generator, you must:
o Disconnect all loads
o Shut off fuel supply
o Store the generator properly
o Plan on exercising the engine regularly unless the generator is prepared for long-term
storage.
Detailed instructions are provided below.
Disconnect loads &
turn off fuel supply
Cool engine before
storing
Choose a storage
location
Prevent accidental
starting
Exercise generator
every 4 weeks
Operation (cont'd)
6. Stopping
7. Storage & Exercise
When you are finished using the generator, disconnect all loads and
turn off all sources of fuel supply:
1. Make sure all devices that were connected to the generator's outlets
are disconnected.
2. If using propane, shut off propane tank valve.
3. If applicable, shut off natural gas line valve.
Let engine cool for at least five minutes before storing. A hot engine can
be a fire hazard.
Store the generator in a location that is:
o Clean and dry
o Away from sources of heat, open flames, sparks, or pilot lights, even
if the generator's fuel tank is empty. Residual fuel in the tank could
ignite.
o Away from extreme high or low temperatures.
Note: Do not store with battery charger always connected. Batteries that
are over-charged can boil themselves dry and produce excessive amounts of
hydrogen, an explosive gas.
Remove key from starter (for electric start engines) and secure key in a
safe location, or remove spark plug(s) in order to ensure the generator
cannot be started accidentally in a storage location or by untrained persons.
The generator should be exercised regularly.
At least every four weeks, start the engine and let it run for 10 to 15 minutes
with a small load plugged in, such as a lamp or fan.
30
Advertisement
Table of Contents
