Table of Contents
Advertisement
USB Mass Storage Reset Delay [20 Sec]
Allows you to set the numbers of seconds POST waits for the USB mass storage
device after start unit command.
Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Device #1/2
Shows automatically detected USB devices.
Emulation Type [Auto]
Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk] [CDROM]
5.4.5
PCIPnP
The PCIPnP menu items allow you to change the advanced settings for PCI/PnP
devices.
Take caution when changing the settings of the PCI/PnP Configuration menu
items. Incorrect field values can cause the system to malfunction.
Advanced
Advanced PCI/PnP Settings
WARNING: Setting wrong values in below sections
may cause system to malfunction.
Plug And Play O/S
PCI Option ROM Scan Order
Onboard Option ROM Priority
Onboard LAN1 Boot
Onboard LAN2 Boot
Plug And Play O/S [No]
When set to [No], BIOS configures all the devices in the system. When set to
[Yes] and if you install a Plug and Play operating system, the operating system
configures the Plug and Play devices not required for boot.
Configuration options: [No] [Yes]
PCI Option ROM Scan Order [Bus 0 First]
Allows you to configure the scanning order of PCI option ROM.
Configuration: [Bus 0 First] [Bus N First]
Onboard Option ROM Priority [High]
Allows you to configure the priority of onboard option ROM.
Configuration: [Normal] [High]
5-22
BIOS SETUP UTILITY
[No]
[Bus 0 First]
[High]
[PXE]
[PXE]
NO: lets the BIOS
configure all the
devices in the system.
YES: lets the
operating system
configure Plug and
Play (PnP) devices not
required for boot if
your system has a Plug
and Play operating
system.
Chapter 5: BIOS setup
Advertisement
Table of Contents
