Performing The 8000 Hour Overhaul - Siemens E382 EH81E 061 01 03 02 Service Manual

Maintenance
42
Performing the 8000 hour
overhaul
1. Replace inlet and outlet valves, cylinder
and head gaskets, piston rings, piston
seals and rider rings in the compressor.
Also replace the rubber seals in the
manifold pipe. See instructions in the
chapter Disassembling and assembling,
section Compressor.
2. Replace the drive belt. See instructions in
the chapter Disassembling and assemb-
ling, section Drive belt.
3. Replace the O-ring and filter insert in
water separator 2. See instructions in the
chapter Disassembling and assembling,
section Water separator 2.
4. Replace the restriction washers, mesh
nets and plastic rings in the two filter/
solenoid valves. See instructions in the
chapter Disassembling and assembling,
section Filter/solenoid valves.
5. Replace the pressure regulator
diaphragm. See instructions in the chapter
Disassembling and assembling, section
Pressure regulator.
6. Replace the air inlet filter and the dust
filters. See section "Performing the 2000
hour overhaul" in this chapter.
7. Inside the Compressor Compact, inspect
air tubing and electrical wiring with
connections. Tighten any loose connec-
tions and replace any item that is
damaged.
8. Adjust the pressure regulator as
described in the chapter Adjustments.
9. Perform a functional check. See
instructions in the Operating Manual,
chapter Functional check.
Siemens-Elema AB
Compressor Compact
E382 EH81E 061 01 03 02