Sounding A Panic Alarm; Memory Feature; Deactivating/Activating Power Door Lock Disable Feature - Ford 2004 F150 Owner's Manual

Locks and Security
• the ignition is turned to the 3 (ON) position, or
• using the UNLOCK
control on your remote entry transmitter or
unlocking via the keyless entry keypad.

Deactivating/activating power door lock disable feature

You must complete Steps 1–5 within 30 seconds, or the procedure will
have to be repeated. If the procedure needs to be repeated, you must
wait a minimum of 30 seconds to begin again.
1. Turn the ignition to the 3 (ON) position, then press the UNLOCK
button three times.
2. Turn the ignition to the 1 (OFF/LOCK) position, then press the
UNLOCK button three times.
3. Turn the ignition to the 3 (ON) position, and within five seconds,
press the LOCK button two times. Two horn chirps should be heard,
indicating that the system has been disabled. Conversely, two horn chirps
followed by a honk will indicate that the system is enabled.
4. Pressing the power door LOCK button two times again will turn the
feature ON if it was previously OFF, or OFF if it was previously ON.
Every two consecutive presses of the LOCK button after successfully
entering the configuration mode will change the enable/disable condition
of the feature.
5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming.

Sounding a panic alarm

Press to activate the alarm. Press again or turn the ignition to 2
(ACCESSORY) or 3 (ON) to deactivate.
Note: The panic alarm will only operate when the ignition is in the 1
(OFF/LOCK) position.
Memory feature (if equipped)
The remote entry system can also control the memory feature.
Press the control once to unlock the driver's door. Pressing the
control will automatically move the seat and adjustable pedals to the
desired memory position (the memory position corresponds to the
transmitter being used).
86