Fiat Panda 4x4 User Manual page 6

fig. 3
fig. 4
❒ take out the tool bag fig. 3 set under the
driver's seat and take it near the wheel
to be changed;
❒ loosen the clamping device B-fig. 4;
❒ take the space-saver spare wheel A;
❒ loosen the bolts on the wheel to be
replaced with the wrench provided A-
fig. 5;
F0G0607m
fig. 5
F0G0608m fig. 6
❒ turn the jack handle to open it partly;
❒ place the jack near the wheel to be
changed in line with mark O on the
sidemember fig. 6;
❒ make sure the groove F on the jack fits
correctly into the sidemember ridge G;
F0G0609m
fig. 7
❒ alert other passengers that the car is
about to be raised; all persons should
be kept away from the car until it has
been lowered again;
❒ fit handle H-fig. 6 to the jack device I
and raise the car until the wheel is a few
inches off the ground. When turning the
jack handle make sure that it can be used
easily and take care not to scrape your
hand against the ground. The moving
F0G0610m
parts of the jack (screws and joints) may
also cause injury if touched. Clean off any
grease;
❒ remove the wheel cap (if any) after un-
screwing the three relevant bolts then,
unscrew the fourth bolt L-fig. 7 and re-
move the wheel;
F0G0233m
5