Quick Start: Getting Up To Speed - Traxxas 3602 User Manual

QUICK START: GETTING UP TO SPEED

The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom
corners of Quick Start pages.
1. Read the safety precautions on pages 3-4
For your own safety, understand where carelessness and misuse
could lead to personal injury.
2. Charge the battery pack • See page 10
Charge your battery now so it will be ready when you finish the
other setup procedures.
3. Install batteries in the transmitter • See page 10
The transmitter requires 8 AA alkaline or rechargeable batteries.
4. Install battery pack in the model • See page 11
Your model requires a fully charged 7.2-volt battery pack.
5. Install the antenna • See page 11
Install the antenna mast in the model.
6. Turn on the radio system • See page 13
Make a habit of turning the transmitter on first, and off last.
7. Check servo operation • See page 13
Make sure the steering servo is working correctly.
8. Range test the radio system • See page 13
Follow this procedure to make sure your radio system works properly
at a distance and that there is no interference from outside sources.
9. Detail your model • See page 9
Install wings (if necessary) and apply other decals if desired.
10. Drive your model • See page 16
Driving tips and adjustments for your model.
11. Maintaining your model • See page 21
Follow these critical steps to maintain the performance
of your model and keep it in excellent running condition.
The Quick Start Guide is
not intended to replace the
full operating instructions
available in this manual.
Please read this entire
manual for complete
instructions on the proper
use and maintenance of
your model.
Look for the Quick Start
logo at the bottom of
Quick Start pages.
TRAXXAS • 7