Scan Modes; Memory Scan - BENDIXKing KX 99 Operator's Manual

The transmit frequency of 122.10MHz
may now be entered. Depress the
keys on the keyboard in the following
order:
I ]
+ 1 2 )
+ F l + F l
+ I 1
Two seconds after a valid
frequency has been entered the
display will revert back to the receive
frequency and any appropriate CDI
indication. The transmit frequency
may be checked by momentarily
depressing the Mike Key button on
the side of the unit. The frequency
window will display the transmit
frequency any time the unit is
transmitting.
Scan Modes
The scan modes allow the user
to sequentially step through a group
of frequencies to find an active
frequency. When a transmission is
received, the radio will stop scanning
and remain on that frequency until the
activity stops. After the frequency has
been inactive for 2 seconds, the scan
process will resume. There are 2 scan
modes, memory scan and frequency
I
I I 1 I 1 1 1 I 11'1'1 I 1 I
I
I I I I 1 1
;;
0901
I 1.00
For memory location 0 to receive
and transmit on the same frequency,
the frequency must be entered first as
the receive frequency and then again
as the transmit frequency.
scan. Before initiating either scan
mode it is important to have the
squelch knob properly adjusted such
that the background noise in the
speaker is just eliminated. That is.
any further counterclockwise rotation
would cause the background noise to
return. If the unit is keyed during scan
operation the scan will be disabled
and the unit stay tuned to the
frequency it was tuned to when the
unit was keyed.
Memory
Scan
To enable the scanning of
Memory Locations 0 through 9
depress the keys on the keyboard in
the following order:
FI+ISCNJ
The unit will now begin scanning the
frequencies stored in Memory
Locations 0 through 9 that have not
been locked out. An "S" will be
displayed in the lower right side of the
display to indicate a scan mode has
been activated.
The Memory Scan mode can be
cancelled by again pressing the MEM
key followed by the SCN key.
17