Field Wiring - Lennox E36ODGNE Installation Instructions Manual

FIELD WIRING

Caution: Label all wires prior to disconnec-
tion when servicing controls. Wiring errors
can cause improper and dangerous opera-
tion. Verify proper operation after servicing.
Refer to Figure 10 for the wiring schematic
for these fireplaces.
This fireplace is completely wired internally.
On the right hand side of the fireplace, at the
rear, are four (4) wires required to connect the
Battery and switch for operation.
Two brown wires are for the connection of the
switch. These are labeled SW and SW. A black
and red pair are for connection to the battery
pack. These are labeled (+) and (–).
These wires are for low voltage current. An
electrical box has been provided to contain
both the switch and battery pack. Mount the
box in an appropriate location within the length
of the wiring provided. Feed all four wires
through one of the lower inlets to the box.
Connect the switch wires to the switch and the
corresponding (+), (–) to the battery holder.
Install two D-cell batteries (not provided) and
test the switch before closing the switch box
( refer to Figure 11 ). The igniter should spark
to the pilot when the switch is on.
10
INTERMITTENT ELECTRONIC WIRING DIAGRAM
WALL SWITCH BOX
BATTERY
BROWN
BROWN
Figure 1
0
Weather Seal
Cover
Switch
Figure 1
1
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
IGNITOR MODULE
3V
BLACK (IGNITOR)
BLACK (SENSOR)
BLACK
ORANGE (THTP)
BLACK (TP)
RED
LIMIT
SWITCH
GREEN (TH)
UMBILICAL CORD (9 Feet)
Orient Batteries Vertically
To Fit Within Box
SPARK TO PILOT IGNITOR
HI
LO