Table of Contents
Advertisement
Troubleshooting
Problem
No Video (black screen)
No Video (one camera)
No Video (jumbled colors)
Fuzzy Image (one camera) Check camera focus
Bad Video (one camera)
Wrong Language
Buttons Locked
Recorded Video Rolls
Tape Plays Only 2x2
Too Many Motion Alarms
Motion Not Detected
Appendix A
Try This
Check power connections
Check camera power and coaxial cable
Make certain multiplexer is set correctly for
your system (NTSC or PAL)
Check the loop through connector.
If a cable is attached, make certain it is
connected to another video device on the
other end.
Change the language in the Setup Menu
Unlock buttons in Setup Menu.
Check VCR configuration in Setup Menu.
Use the trigger pulse from the multiplexer
for optimum synchronization with a time-
lapse VCR.
Make certain video cable to the VCR input
is connected to the VCR OUT of the
multiplexer.
Adjust sensitivity of motion detection grid.
Adjust size of grid required to activate
motion alarm. Make certain only the area
you want to detect motion is activated.
Adjust sensitivity of motion detection grid.
Adjust size of grid required to activate
motion alarm.
Make certain the area you want to detect
motion is activated.
71
Advertisement
Table of Contents
