Philips DVDR3380 Service Instructions Manual page 7

B. Procedure to apply the software upgrade:
1. Open the tray and load the Upgrade CDROM with Software upgrade file.
2. The tray closes and set will display:
"Upgrading SW"
3. The OSD will display
"Software Upgrade Disc detected.Select OK to start upgrading or CANCEL to exit ."
4. Click on the OK button.
5. The set will display:
"Upgrading SW"
and the OSD will display
"Upgrading Software. Please Wait. Do not switch off the power."
The whole process takes less than 5 minutes
Note: Do not press any buttons or interrupt the mains supply during the upgrading process, otherwise the set may becomes
defective.
6. When the upgrade is completed the tray will open automatically and the set will display:
"System is successfully upgraded.Remove disc from tray and reset system."
7. The tray open and the set will display:
"SW DONE"
and the tray will open automatically for user to remove CD-ROM.
8. Press <OK> and the set goes to standby .
C. How to read out the firmware version to confirm set has been upgraded:
1. Power up the set.
2. Ensure no disc inside the loader,if no ,open the tray to remove the disc and close the tray.
3. Press <0> <0> <0> <9> in succession
4. Press <OK> button
5. The TV connected to the set will display:
"DVDR3380_EU_V03_07,Region:2, Drive 45.04.05.04
Build 0091 Mar 7 2006,12:17:31 Stroke:31 "
Firmware Upgrading
3139 785 31810 3.
EN 7