Table of Contents
Advertisement
S AMP LE
TIP 2: If you are about to make a lot of recordings of a similar type, put the note number first
(i.e. C#3 PIANO, E 3 PIANO, G 3 PIANO, etc.). In this way, you don't have to cursor through
the whole name to give the sample its unique note identifier.
Once you have named the sample, you are now ready to make a new recording. First,
however, let's have a quick look at the parameters on this page.
NOTE: To set the note from a MIDI controller, you must be monitoring the input signal (i.e. F7
should be showing
as the S3200XL.
The page also shows what percentage of memory is free, the current sample rate (44100) and
the size (expressed as a percentage of available memory) of the sample you are about to make.
Page 124
You may select to record in MONO or STER(eo). When you opt to record in
stereo, two samples will be created and -L and -R will be appended to each of
them to indicate the left and right sample.
This sets the note on which the new sample will be placed when you record it.
The default is C 3 but you may set any note you like. You will note that you can
set the note by specifically moving the cursor to this field and using the DATA
wheel or you may set it by playing the note on your MIDI controller (i.e.
keyboard).
) and, of course, the controller should be on the same MIDI channel
This sets the length of time you will record for.
S3200XL Operator's Manual - Version 1.00
Advertisement
Table of Contents
