Master Section Description; M A I N O U; Efx Out(Mm1202 Ony); Aux Out - Phonic MM1002 User Manual

MASTER SECTION DESCRIPTION

13 MAIN OUT
These sockets send line level signals
from the mixer to external devices (for
example: EQ or a power amplifier).
14 EFX OUT (MM1202 only)
This socket sends out the signals from
mix bus.

15 AUX OUT

This socket sends out the signals from
aux bus.
16 CTRL RM
This jack socket sends the mix sig-
nals to the control room speakers.

17 REC

The signals are sent to the tape re-
corder via the associate RCA sockets.
18 2T RTN
These 2 RCA jacks are for the 2T tape
return to the mixer.
19 EFX OUT CONTROL(MM1202
ONLY)
This knob controls the mix signals level
send to the external effect.
20 AUX OUT CONTROL(MM1202
ONLY)
This knob controls the AUX OUT level.
21 +48V PHANTOM PWR
This slide-switch turns the master
phantom power on and off.
PHONIC CORPORATION

22 LED LEVEL METERS

LED meter shows the level of mas-
ter mix L and R in the stereo mode:
In the MS mode, the left hand side
meter shows the M signal level, the
right hand side shows the S signal
level.
23 HEADPHONE / STEREO IN-
DICATION SELECT BUTTON
Push down to select the meter to
show headphone level, release it to
show the main stereo output level.

24 MS/ST SELECT BUTTON

The switch select the LED LEVEL
METER are in the MS or STEREO
mode, in the MS mode; the left
channel of the LED LEVEL METER
represents the M signal, the right
channel of the LED LEVEL METER
represents the S signal. Two LED
level are always different. The
closer the difference between two
levels the wider the stereo image
you can get. If only the M signal of
the meter shows, the master out-
put is MONO. If S level is higher
than M, the stereo is out of phase.
25 2T RTN SIGNAL PATH SE-
LECT BUTTON
Push down the right button feeds
the 2T RTN signals into MAIN L/R
output. Push down the left button
feeds the 2T RTN signals into con-
trol room and effected by the con-
trol room level.
MM1002 / MM1202 USER'S MANUAL
MASTER SECTION DESCRIPTION
Page 13