Audiovox VME 9309TS Owner's Manual page 13

Parameter Adjustment Procedure
1. Enter Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the BAND/PC button (4) on the monitor.
2. Select Item to Set:
Press the AUDIO button (5) on the control panel to select "BRIGHT" or "CONTRAST".
3. Set Parameters:
Press the +/– buttons (15, 16) on the remote or turn the rotary encoder (5) on the control panel.
4. Exit Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the BAND/PIC button (4) on the monitor
Table 2: Video Output Modes
Playing Source
AM/FM TUNER
DISC
AUX 1 + 2
NAV
CAMERA
* CVBS - Composite Video Baseband Signal
Parking Brake Inhibit
• When the "PRK SW" cable is connected to the brake switch, the display on the TFT monitor will display video only when the vehicle is applied.
• Parking brake function is overridden when the video source is set to CAMERA.
• When the parking brake inhibit is active, the front monitor displays "Parking Is On", preventing the driver from watching content while driving.
Rear video screens are not affected.
Mute
Press the MUTE button on the front panel (6) or remote control (3) to mute the volume from the unit. Press the MUTE button again to restore the
volume. "MUTE" is displayed on the LCD. Adjusting the volume or using any of the audio setup features cancels the mute function. External peri-
pheral devices can be connected to this unit via RCA output or MediaLink. Select "AUX" mode to access and control connected auxiliary devices.
Monitor Movement Mechanism
If an obstruction occurs in the monitor path, the following protective measurements can be executed to prevent damage to the mechanism or
monitor:
After the protective procedure is executed, normal operation is resumed by pressing the OPEN button (1) or disconnecting and reconnecting the
power.
Obstruction
Monitor loading out horizontally Unit stops at obstruction point Monitor fully extended
Monitor loading in horizontally
Monitor loading out horizontally Unit stops at obstruction point Monitor swivels back to the unit Monitor swivels back to the unit
Monitor loading in horizontally
Table 3: Monitor Protective Measures
Video Output Modes
RGB Mode
RGB Mode
CVBS Mode
RGB Mode
CVBS Mode
Self Protection
Unit stops at obstruction point Monitor fully extended
Unit stops at obstruction point Monitor swivels back to the unit Monitor swivels back to the unit
OPEN Button Pressed
horizontally
horizontally
13
Power Reconnected
Monitor is automatically loaded into unit
Monitor is automatically loaded into unit