Schwinn Echelon Console Owner's Manual page 8

Workout Totals
The TOTAL display field shows the total time and distance for the entire workout period.
Keypad
The multi-function keypad lets you set the console measurements for your workout, see and update your workout data, and
examine the console diagnostic messages. Tap any button to activate the console from Sleep Mode. The Operations section of
this manual gives the procedures for using the buttons in each Operations mode. The Backlight button sets your selections in
User Setup Mode and Service Mode.
Battery Level
The Battery Level icon shows the battery level for the console. All four segments of the icon are on when the battery level is high.
When the battery level is low, only the bottom segment is on. The bottom segment flashes when battery level is very low.
If the battery level is too low to continue operation, the console display flashes the message "LO batt" and the console goes into Sleep Mode.
If this occurs during a workout, the workout stops and the console display shows the workout results for 10 seconds. Then the "LO batt" message
displays and the console goes into Sleep Mode.
Bike Sensor Data
The console receives data from the bike's sensors and uses the data to calculate workout results.
RPM Sensor
The Schwinn® MPower™ Echelon Console comes with a RPM sensor for the bike . This sensor transmits data from the flywheel to
the power sensor and the console.
Power (Watts) Sensor
The MPower™ Power sensor is an optional upgrade for a Schwinn A.C.™ bike with a Schwinn® MPower™ Echelon Console. The
power sensor calculates rider Power (Watts) production from the brake resistance mechanism.
To install the power sensor, refer to the Schwinn® MPower™ Echelon Power Upgrade Installation Guide.
8