Advertisement
unpackInG
When unpacking, check to make sure that
the item is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight Tools
at the number shown on the cover of this document
as soon as possible.
IMportant saFetY InForMatIon
1.
Use this product only according to these in-
structions. Improper use can create hazards.
2.
Wear ANSI-approved safety goggles and
heavy duty work gloves during use.
3.
cautIon!
Keep hands and fingers away
from the Crimping Dies (7) when using this
product. This tool creates approximately
eight tons of crimping force.
4.
cautIon!
Do not use extension for added
leverage on the Fixed Handle (14) of this tool.
5.
WarnInG!
NEVER attempt to crimp wires
that are plugged into an outlet and are electri-
cally charged ("live").
6.
Refer to the wire manufacturer's instruction
manual for specific wire crimping instructions
prior to using this product.
7.
Keep work area clean and well lit.
8.
Do not overreach. Keep proper footing and
balance at all times. This enables better con-
trol of the product in unexpected situations.
9.
Keep bystanders out of the area during prod-
uct assembly and use.
10.
Do not assemble or operate when tired or
when under the influence of drugs or medica-
tion.
11.
This product is not a toy.
dren to play with or near this product.
12.
Use for intended purpose(s) only.
13.
Inspect before use.
missing or damaged.
14.
Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
SKU 66150
Do not allow chil-
Do not use if parts are
For technical questions, please call 1-800-444-3353.
product Features
FIXed Handle
HYdraulIc oIl return ValVe
(14)
puMp Handle
(13)
operatInG InstructIons
read the entIre IMportant
saFetY InForMatIon including all
text under subheadings therein before
set up or use of this product.
1.
Check to make sure the Hydraulic Oil Return
Valve (17) is in its "oFF" position.
(see Figure a.)
2.
Provided with this product are
sets of Crimping Dies (7). Select the size of
Dies (aWG) 00-0-2-4-6-7-8-10-12 you wish
to use and insert them into the Pincers Head
(8) of the tool. (see Figure a.)
3.
Insert an electrical terminal (not included)
onto the bare end of a wire. Then place
the terminal with its wire between the set of
Crimping Dies (7) on the tool.
(see Figure a.)
4.
Turn the Hydraulic Oil Return Valve (17) to its
"on" position. (see Figure a.)
5.
Grip the tool firmly. Then slowly squeeze the
Pump Handle (13) as many times as neces-
sary to fully crimp the terminal onto the wire.
(see Figure a.)
6.
Once the terminal is crimped, turn the Hy-
draulic Oil Return Valve (17) to its "oFF"
position to fully retract the Crimping Dies.
Then remove the crimped assembly.
(see Figure a.)
7.
Make sure to store the Hydraulic Wire Crimp-
ing Tool in its Carrying Case and keep the
Case in a clean, dry, safe location out of
(17)
crIMpInG dIes
(7)
FIGure a
nine matching
Page 2
Advertisement
