Toshiba RAV-SP404ATP-E Installation Manual page 10

Split type outdoor unit
Hide thumbs Also See for RAV-SP404ATP-E:
Table of Contents

Advertisement

Necessary Space for Installation
(Unit: mm)
Obstacle at rear side
Upper side is free
1.
Single unit installation
2.
Obstacles on both right and left sides.
The height of the
obstacle should be
lower than the height
of the outdoor unit.
150 or
300 or
more
more
3.
Serial installation of two or more units
150 or
300 or
300 or
300 or
more
more
more
more
The height of the obstacle should be lower than
the height of the outdoor unit.
Obstacle also above unit
150 or
more
EN-17
Obstacle in front
Above unit is free
1.
Single unit installation
2.
Serial installation of two or more units
Obstacle also at the above unit
1,000 or
more
- 9 -
Obstacles in both front and rear of unit
Open above and to the right and left of the unit.
The height of an obstacle in both the front and rear of the
unit, should be lower than the height of the outdoor unit.
Standard installation
1.
Single unit installation
2.
Serial installation of two or more units
300 or
more
Serial installation in front and rear
Open above and to the right and left of the unit.
The height of an obstacle in both the front and rear of the
unit should be lower than the height of the outdoor unit.
Standard installation
1,000 or
300 or
1,500 or
2,000 or
more
more
more
Installation of Outdoor Unit
• Before installation, check the strength and
horizontalness of the base so that abnormal sounds
do not emanate.
• According to the following base diagram, fix the base
firmly with the anchor bolts.
(Anchor bolt, nut: M10 x 4 pairs)
90
Ø25 Drain hole
• As shown in the figure below, install the foundation
and vibration-proof rubber pads to directly support the
bottom surface of the fixing leg that is in contact with
and underneath the bottom plate of the outdoor unit.
* When installing the foundation for an outdoor unit with
downward piping, consider the piping work.
GOOD
300 or
more
Fixing leg
Foundation
GOOD
Foundation
Support the bottom surface of
the fixing leg that is in contact
with and underneath the bottom
plate of the outdoor unit.
200 or
more
more
NO GOOD
If only the
end of the
fixing leg is
supported, it
may deform.
Foundation
600
90
108
Absorb vibration
with vibration-proof
rubber pads
Bottom plate of
outdoor unit
Do not support
the outdoor unit
only with the
fixing leg.
EN-18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents