Pioneer VSX-D608 Service Manual page 60

VSX-D608
Remote Control Unit
RECEIVER
ENTER
VOL
CHANNEL
MULTI CONTROL
DVD/LD TV/SAT
VCR 1
TV CONTROL
VCR 2
RECEIVER
DSP MODE
1 2
CH.SELECT TEST TONE
6
5
CN.LEVEL
9
0
FUNCTION DIRECT
MODE CHECK
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
1 RECEIVER button
Press to switch the receiver on or to put in standby.
2 MUTING button
Press to mute the volume. "MUTING" appears in the
display. Press again to cancel.
3 %˜fi˜@˜#˜ENTER buttons
Specific use of these buttons is described in conjunction
with the operations they are used in.
ENTER : Press to switch the band (FM/AM) when using
the tuner.
4 VOL (+/–) buttons
Press to adjust the volume. When VOL (+/–) buttons are
pressed while muting, muting is canceled.
5 CHANNEL (+/–) button
Use to select preset stations when operating the tuner.
When the remote is used to control other components,
this button may be used to change channels, tracks, or
chapters.
6 MULTI CONTROL buttons
Use these buttons to select the source and
corresponding remote operation mode.
For example, pressing TUNER selects the built in tuner
and sets the remote to operate the tuner functions.
60
TV
FQ
+
–
FQ
VOL
CD
TUNER
MD/TAPE
MIDNIGHT
3 4
ATT SIG.SELECT
8
7
EFFECT
+10
MEMU
CLASS TV/VCR
FL DIMMER
COMMANDER
SET UP
7 Number buttons
These buttons can perform a variety of different functions
depending on the remote operation mode.
• [RECEIVER operations (press RECEIVER first)]
: Press repeatedly to select the standard Dolby/DTS
mode and the ADVANCED THEATER modes.
DSP MODE : Press repeatedly to select a DSP sound
mode.
MIDNIGHT : Press to hear surround sound effectively at
low volumes.
CH.SELECT : Use to select a speaker when adjusting
speaker levels.
TEST TONE : Press to switch the test tone on or off
when listening to a surround mode.
ATT : Press to attenuate (lower) the level of the input
signals and prevent distortion (refer to "Display" 5
Overload indicator).
SIG.SELECT : When the same component uses both
analog and digital connections, use to select input signals
as digital or analog.
CH.LEVEL (–/+) : Use to adjust individual speaker levels.
EFFECT (+/–) : Use to adjust the DSP mode effect level.
• [TUNER operations (press TUNER first)]
Number buttons (0~9) : During preset tuning, use to
input the number of the preset station. Use to input the
station frequency during direct tuning.
CLASS (+10) : Press repeatedly to switch the preset
station classes during preset tuning.
MENU : Press to activate direct tuning.
8 FUNCTION button
Press repeatedly to select a source.
9 MODE CHECK button
Press to confirm the current remote operation mode and
to switch operation modes without changing the source .
0 Power button
Press to turn on or put in standby all connected
components other than this unit.
- TV/TV FUNC button
Press TV to turn the TV's power on or put in standby.
Press TV FUNC to select the TV for remote control
operation.
= RECEIVER button
Press to select the receiver for remote control operation.
~ FL DIMMER button
Press to adjust the brightness of the fluorescent display.
Four levels of brightness ranging from very dim to very
bright can be selected.
! COMMANDER SET UP button
Use to customize the remote control functions.
@ DIRECT button
Use to playback original source audio. When DIRECT is
ON, Dolby, DSP, LOUDNESS, DNR and MIDNIGHT
mode are automatically turned OFF.