C Basic Operation 2 Digital Effect Bloc - Panasonic WJ-MX50 Operating Instructions Manual

B-5. Position Control
The position of the specific wipe pattern can be
changed on the monitor screen using Position Control
function
• Press the Square Wipe Button (60) and select the
desired wipe pattern by pressing this button repeatedly
• If necessary, change the aspect ratio by using the
Aspect Control (29) and Aspect ON/OFF Button (30)
• Press the ON Button (3)
double)
• Adjust the Mix/Wipe Lever (99) to obtain the desired
wipe size
• Operate the Positioner Joystick (2) The position of the
wiped scene can be changed on the monitor screen
• When the SCENE GRABBER Button (4) is selected
together with the ON Button (3), the scene in the wipe
pattern will be "grabbed"
• Operate the Positioner Joystick (2) The position of the
"grabbed" wipe scene can be freely set on the monitor
screen
Note:
When the ON Button (3) is turned off, the SCENE
GRABBER Button (4) becomes off
(The wiped size becomes
C. Basic Operation-2
Digital Effect block
The following instructions detail the Digital Effect block
function which generates digital special effects for the
A-bus and B-bus source video signals
the desired effect(s) on the A-bus (B-bus) signal, press the
A-Button (58) (B-Button (57)) and the ON-Button (59)
Notes:
1. The selected effect(s) can be added to either the A-bus
or B-bus at one time
2 Without pressing the ON Button (59), the digital
effect(s) will not applied on the A-bus or B-bus signal
1. Negative
Press the NEGA Button (31) The negative image (like
a film negative) is obtained The Colour Correction can
also be added with this function
Normal Image
2. Press the MOSAIC Button (33)
box-like pattern is obtained The size of the mosaic
pattern can be adjusted continuously for up to 31
increments by adjusting the SIZE Control (32)
- 2 0 -
In order to add
Negative Image
A mosaic-like or