Problems And Solutions - Oster 3157 Instruction Manual

PROBLe MS AND SOL u TIONS
PROBLEM
Juice Extractor will not work
after switching on "I".
Motor makes loud noise and
unit starts vibrating.
Motor appears to stall when
juicing.
Too much pulp build up on
stainless steel filter.
Pulp too wet and reduced juice
extraction.
Juice leaks between the rim of
the Juicer and Cover
the Filter.
SOLUTION
• Safety locking arm may not be locked properly in
its position.
• Turn off and unplug unit and ensure all parts are
assembled properly.
• Turn off and unplug unit and check if there are
any residues blocking the unit.
• Turn off and unplug unit and ensure all parts are
assembled properly.
• Juicing overripe fruits may produce too much
pulp and clog the filter. Turn off and unplug unit
and clean the filter thoroughly.
• If pulp starts building up under the lid, slow down
the juicing process. Turn off and unplug unit and
clean the filter basket, the stainless steel filter
and the lid.
• Follow the instructions to disassemble the unit
included in the "After Using Your Juice Extractor"
section. Clean up pulp from the filter.
• Try a slower juicing action. Remove stainless
steel mesh filter and thoroughly clean mesh with
a nylon brush. Rinse the filter basket with hot
water. If the fine mesh holes are blocked, soak
the basket in a solution of hot water with 10%
lemon juice to unblock the holes or wash in the
dishwasher. This will remove excess fiber build
up (from fruit or vegetables), which could be
reducing the flow of juice.
• Try a slower juicing action by pushing the Food
Pusher down slower.
8