Advertisement
Available languages
Available languages
BDA 29947_Layout 1 29.03.11 13:16 Seite 5
Troubleshooting
Problem
Bad reception
or no reception
Moderate reception
Technical data:
ntenna
Input voltage:
VHF Frequency Range:
UHF Frequency Range:
Polarisation:
Power supply
Input voltage:
Output voltage:
Output current:
Stand-by consumption:
Operating temperature:
Hereby Vivanco GmbH declares that TV 402 is in conformity with the fundamental requirements
and other relevant regulations of the directive 2004/108/EU.
Disposal of the device
This device may not be disposed along with household waste. Please hand it over to a collection
point for electrical devices of your area or your district. Thus it will be guaranteed that the old
devices are recycled properly and economically and potential environmental and health hazards
are avoided.
The packing should be supplied to re-use. Please do not throw it into household waste and
handle it in conformity with local disposal rules.
Possible cause
ntenna is not connected
to a power supply
ntenna is switched off
Cable connection broken
ntenna is not aligned properly
Inconvenient position of the
antenna was selected
Room is heavily shielded from the
transmitter (can also be
recognised through bad
reception of the mobile phone)
There is no sufficiently strong
transmitter in the vicinity
5/6 V=
174-230 MHz
470-862 MHz
Vertical and horizontal
230 V~ 50 Hz, Euro plug
6 V
50m
<0,3 W
5...35 °C
Solution
Ensure power supply
Switch on antenna
Check if all the plug
connections are plugged in
properly
Turn the antenna till the best
reception is set up
Place the antenna in another
position in the room
Use window or external
antenna
Please check with your
provider if you are in the range
of the transmission antenna
GB
5
Advertisement
