Advertisement
H. NFC (Near Field Communication) Mode(Only Applicable to Speakers with NFC feature)
Switch On the speaker and turn to bluetooth Mode and activate "NFC" in your mobile. Touch the mobile on the
"NFC" sensitive area of the speaker( Left top corner of the speaker) and the mobile will get connected to the
bluetooth speaker and the speaker is ready to use with the mobile.
8. Speaker Charging
The speaker has got a Built in rechargeable battery. Connect the provided USB cable to computer or into DC 5V
power adaptor. The LED light will turn to Red color when the speaker is being charged and when speaker is fully
charged, the Red LED will turn off. (The charge time is approximately 5 hours). Unplug the Speaker from the Power
device once the speaker is fully charged.
9. Compatibility
Wireless：With BLUETOOTH V2.1+EDR Including A2DP, AVRCP, HFP/HSP,OPP, PBAP
10. Trouble Shooting Guide
Should you experience any difficulty while using the speaker , Please refer to the following Chart.
Fault
Not Charging
No Sound
No
Audio
Signal
via
Bluetooth Connection
Speaker cannot be Connected
Poor Sound quality from a
Bluetooth device
The right to make technical and design modifications in the course of Continuous product development remains reserved. This device has been tested according to all
relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety
regulations.
Reason
The USB power adaptor (not included) is not plugged
into a wall outlet or the USB cable (included) is not
plugged into the mini USB jack behind the speaker.
Wall outlet is not functioning.
Computer USB port is not function.
The speaker battery is dead.
The speaker is not linked to the cell phone.
Volume set is too low.
Speaker is not paired to the audio source.
Volume too low
Pairing does not work
Audio source is switched off
Bluetooth is switched off at the audio source.
Bluetooth version is not supported.
Bluetooth device is almost out of range of the speaker
Solution
Plug the USB power adaptor (not included) into a wall outlet and plug
the USB cable (included) into the mini USB jack of the speaker.
Plug another device into the same outlet to confirm the outlet is
working.
Make sure your computer power is turned on and try another USB
port.
Recharge the speaker
Go through "Speaker Operations" process to connect the speaker.
Increase the volume of your device.
Check whether a connection exists. If necessary pair the speaker
again to the audio source
Increase the volume on the speaker
Increase the volume on the audio source.
Check whether the audio source supports the A2DP protocol
Switch on the audio source
Switch on the Bluetooth function in the audio source.
Use a different playback unit.
Move your Bluetooth device closer to the speaker
Advertisement
