Table of Contents
Advertisement
Display shows: "Excess De-
tergent"
Display shows:
– "No drain - check/drain
hose/filter" or
– "Pump Blocked"
Fabric softener not rinsed
in,
compartment for ad-
ditives is filled with water.
The door cannot be opened
when the appliance is
switched on.
Washing is heavily creased.
28
Problem
Probably too much de-
tergent has been used.
Kink in drain hose.
Maximum pumping
height of 1m exceeded.
Drain pump is blocked.
For sink spigot connec-
tions: spigot is blocked.
Conditioner insert in the
compartment for addi-
tives is not correctly at-
tached or is blocked.
Door locked.
There has been a power
cut. (All displays are off.)
For safety reasons, the
door will remain locked
for between 4 and 10
minutes.
Possibly too much
washing was loaded.
Possible cause
Remedy
Dose detergent exactly as in-
structed by manufacturer.
Remove kink.
Please contact your Service
Force Centre
Switch off the appliance. Pull
out mains plug.
Clean the drain pump. Re-
move foreign bodies from the
pump housing.
Clean out spigot.
Clean the detergent dispenser
drawer, insert the conditioner
insert firmly.
Wait until the display alternate-
ly shows "Door openable" and
"Cycle ended".
The programme will continue
when the power cut is over.
To remove washing:
If water can be seen in the ap-
pliance, before opening the
door, first perform an emergen-
cy drain.
Observe maximum loads.
Advertisement
Table of Contents
