Mounting Instructions - Audiovox KCD3180 Instruction Manual

MOUNTING INSTRUCTIONS

STEP 1
If your cabinet does NOT have an
overhang:
a) Place the Mounting Template in the
desired location inside or underneath
the cabinet (whichever has less
obstructions, and will be easier for
you to reach to drill holes), flush with
the front edge of the cabinet and
tape it down. Go to STEP 2.
If your cabinet DOES have an overhang:
a) Measure the thickness of the cabinet
overhang (see Figure 1).
Cabinet Bottom
Front
edge
Figure 1
b) Fold the Mounting Template along the
guideline that is closest to the
thickness of your cabinet overhang.
c) Tape Mounting Template to the
underside of the cabinet with the
folded portion of the Mounting
Template flush up against the cabinet
overhang (see Figure 2). Go to
STEP 2.
Cabinet Bottom
Front
edge
Template
Figure 2
STEP 2
Use an electric drill with a ¼" drill bit (not
included) to drill all four holes marked on
the Mounting Template (see Figure 3). To
reduce splintering, please a small piece of
masking tape over each hole location
before drilling. Go to STEP 3.
Template
Figure 3
STEP 3
If your cabinet does NOT have an overhang:
a) Eight screws are included with this
unit, but you will only need four of
them. Select the screw length which
will go completely through your
cabinet bottom, and provide at least
3/8" of thread to screw into the main
unit.
b) Insert the four selected screws
through each hole from the inside of
the cabinet going down (see Figure4).
Figure 4
(Continued on next page)
- 6 -
Mounting
Screw