Previous Destinations - Mercedes-Benz COMAND Operating Instructions Manual

Select From Memory From Memory
X
firm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
X
the character bar: enter characters using
the character bar (
Y
Option 2: destination memory list as
X
selection list: select a destination by turn-
ing cVd the COMAND controller and press
W to confirm.
You see the address data of the selected
entry.
Select Delete Delete and press W to confirm.
X
A prompt appears asking whether you wish
to delete the destination.
Select Yes Yes or No No and press W to confirm.
X
If you select Yes Yes, COMAND deletes the
destination. You will see a message to this
effect.
If you select No No, the process will be can-
celed.
i
If the navigable address data for the des-
tination being deleted is also assigned to
an address book entry, COMAND will also
delete this data from there. If the corre-
sponding address book entry does not con-
tain any further data, such as telephone
numbers, COMAND deletes the entire
address book entry.

Previous destinations

Introduction
COMAND automatically stores the previous
destinations for which route calculation has
been started. If the memory is full, COMAND
deletes the oldest destination. You can also
save a destination from the list of previous
destinations in the destination memory. It will
be stored there permanently.
and press W to con-
page 36).
Previous destinations
Storing a destination permanently in
the destination memory
Proceed as described in the "From the list
X
of previous destinations" section
( page 70).
Y
Storing the vehicle position in the list
of previous destinations
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Position Position in the navigation system
X
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select Save Save Vehicle Vehicle Position
X
W to confirm.
COMAND stores the current vehicle posi-
tion as a destination in the list of previous
destinations.
Storing the crosshair position in the
list of previous destinations
A crosshair appears on the map if you have
moved the map manually (
can store the crosshair position as a destina-
tion in the list of previous destinations.
To show the menu: press W the COMAND
X
controller.
Select Position Position in the navigation system
X
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select Save Crosshair Position Save Crosshair Position
X
press W to confirm.
Position and press
page 108). You
Y
and
Z
107