Kärcher SGP-302017 Operator's Manual page 9

STeP 7: Turn the engine to "Run" position.
Temperature
Gauge
burner
Swutch
STeP 9: If hot water is required.
Adjust temperature gauge to proper
temperature (00°). Turn on Burner
switch to begin heating water.
variable Pressure
brass Soap
Nozzle
High
variable Pressure
Pressure
Control Handle
Nozzle
Selection of high or low pressure is accompanied by
turning the handle. NoTe: High pressure nozzle must
be inserted at end of wand to obtain high pressure. To
apply soap read operator's manual.
oPerATING INSTrUCTIoNS
Throttle
Safety
latch
WArNING! Never replace noz-
zles without engaging the safety
latch on the spray gun trigger.
Wand (vP)
Trigger
9.800-079.0 • Rev. 4/08
STeP 8: Pull the starter grip. If the engine fails to start
after  pulls, squeeze the trigger gun to release pressure
and repeat step. Return starter gently. After the engine
warms up enough to run smoothly, move choke to run
position and throttle to fast position.
CAUTION: Small engines may kick back. Do not hold
pull starter grip tightly in hand.
The four color-coded quick connect
nozzles provide a wide array of
spray widths from 0° to 40° and are
easily accessible when placed in
the convenient rubber nozzle holder,
which is provided on the front of the
machine.
NoTe: For a more gentle rinse,
select the white 40° or green 5°
nozzle. To scour the surface, select
the yellow 15° or red 0° nozzle. To
apply detergent select the black
nozzle.
NozzleS
9