Brother S-7200A Service Manual page 20

<When set to condense>
・ Start backtacking or end backtacking must be set.
・ For the sewing start, set stitch number B to "0". Output will occur while stitches for stitch number A are being sewn.
・ For the sewing end, set stitch number C to "0". Output will occur while stitches for stitch number D are being sewn.
Motor
Needle up signal
Option
Stitch number
<When set to chain stitch thread trimming (thread wiping)>
・ After thread trimming, the thread wiper signal is output.
・ Use Function No. 109 and No. 110 to set the timer operation.
Motor
Option
Needle up stop
<When set to pneumatic wiper>
・ After thread trimming, output is synchronized with the automatic presser foot lifter.
・ Use Function No. 111 and No. 112 to set the timer operation.
・ When the presser foot is lowered, option output turns off.
Needle up stop
Motor
Presser foot lifting
Option
Operation
A
Stop
Stitch number D
S-7200A
4. FUNCTION SETTINGS
2254M
2255M
2256M
14