Switching Off The Appliance; Interrupting The Programme; Terminating The Programme; Changing The Programme - Bosch Dishwasher Operating Instructions Manual

Switching off the appliance

Short time after the end of the programme:
– Open the door.
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
m
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.

Interrupting the programme

– Open the door.
– Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch ( again.
– Close the door.

Terminating the programme

(Reset)
– Open the door.
– Press START button h for
approx. 3 sec.
The numerical display 8 indicates
: .
– Close the door.
The programme sequence lasts
approx. 1 min. On the digital display
8 is indicated :
– Open the door.
– Switch off ON/OFF switch (.
– Close the door.
.

Changing the programme

When the START button h has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).

Intensive drying

The final rinse uses a higher temperature
which improves the drying result. The
running time may increase slightly.
(Caution if utensils are delicate!)
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button h until : .... is
indicated on the digital display.
– Release both buttons.
– Press programme button # until the
factory set value :
the digital display 8.
To change the setting:
– Press the button 3 to switch the
Intensive drying on :
– Press START button h.
The set value is saved.
– Close the door.

Interior light *

The interior light 1" comes on when the
door is opened irrespective of whether the
ON/OFF switch ( is switched on or off..
When the door is closed or ajar, the light is
off.
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button h until : .... is
indicated on the digital display.
– Release both buttons.
– Press programme button # until the
factory set value :
the digital display 8.
To change the setting:
– Press the button 3 to switch the
interior light off :
– Press START button h.
The set value is saved.
– Close the door.
* depending on model
aus
is indicated on
or off : .
is indicated on
or on : .
15