Advertisement
Listening to Other Portable Audio Devices:
If you have an iPod without a docking port or a different MP3 player, including
other portable audio devices you may play them through the dock for iPod
iBeam
®
Sound System through the built-in AUX-IN jack, located behind the
main unit.
1. Ensure the speaker dock is OFF.
2. Plug your audio device into AUX IN socket (located behind the main unit).
3. Press the power button
/
NOTE: You may need to turn your external audio device ON as well.
4. Press the skip buttons
OR
5. Press and hold the power button
OFF.
NOTE: You may need to turn your external audio device OFF as well.
Using Headphones (not included):
If you would like to listen to your music privately through the use of headphones,
you may do so in one step. Simply plug your headphones into the phones
socket, located behind the unit. Compatible headphones have a 3.5mm diameter
stereo plug and an impedance of 8-32 Ohms. When your headphones are
connected, the stereo speakers are automatically disconnected.
to turn the speaker dock ON.
to rewind or fast-forward to the next song.
/ more than 3 seconds to turn the unit
8
QUICK REFERENCE TROUBLESHOOTING
If an issue arises, please refer to the points listed below. If you are unable to remedy
a problem by following the table, please consult the SI Products Service Center. The
contact information is listed under the ONE YEAR LIMITED WARRANTY.
WARNING: Other than basic troubleshooting, under no circumstances should you
try to repair the unit yourself, as this would invalidate the warranty. NEVER operate
this appliance if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water.
PROBLEM
POSSIBLE REASON(S)
There is no sound coming
• Volume not adjusted.
from speakers.
• Headphones are connected.
• Adaptor is not correctly
connected to power supply.
The main unit does not
Electrostatic discharge
react to any button being
pressed.
The iPod does not respond
The iPod is not installed properly
to the unit or the iPod did
in the docking connector base.
not charge up.
SOLUTION
• Adjust the volume.
• Disconnect the headphones.
• Connect the adaptor properly.
Turn off the unit, disconnect the adaptor
plug from outlet and then reconnect after
a few seconds.
Remove your iPod from the dock and
check for obstruction on the connectors
in the dock and on the iPod. Then insert it
back into the docking connector base.
9
Advertisement
