Assembly; Fit The Handle; Changing The Diamonds - Husqvarna PG 280 Operator's Manual

Fit the handle

• Remove the screws (A).
• Remove the locking knobs (B).
• Fit the handle in the handle stand-off on the machine.
• Refit screws (A) and locking knobs (B).
• The locking knobs should be positioned in-line with the
handlebar to reduce the risk of damaging the knobs when
laying down the machinge when changing tools.
8 –
English

ASSEMBLY

Changing the diamonds

Shut down the machine and disconnect the power plug.
Have a set of gloves ready, as diamond tools can get very hot.
• Crank up the handlebar to the highest position.
• Pull back on handle to lift grinding head off the ground.
• Lay machine back on the ground.
• Put on gloves.
• Use a hammer to remove the diamond segments.
• Affix new diamond segments on the grinding disc.
• Once new diamond segments have been attached,
reverse procedure to lower machine to ground.