Table of Contents
Advertisement
Installing the Blades
1. Attach the fan blades to the blade holder arms. Three supplied screws, washers, and nuts should be
used to securely attach each blade to each blade holder arm (Fig. 5).
2. Attach the other end of the blade holder arm to the fan motor housing using two supplied screws and
washers (pre-fitted on the bottom of motor housing), for each blade holder arm (Fig. 6).
Fig. 5
Blade
Holder
Arm
Screws and
Washers
Installing the Bulb and Glass
1. Insert a 60W max BC bulb or a 14W energy saving bulb into the lampholder. Do not use a higher
wattage lamp.
2. Secure the lamp shade (Fig. 7a) to the switch housing using the supplied screws. Be careful not to over-
tighten these screws—hand-tighten only (Fig. 7b).
Fig. 7a
Nut
6
ME006-01
Fig. 6
Fig. 7b
10/16/2014
Advertisement
Table of Contents
