Related Manuals for Revolutions Sprint
Summary of Contents for Revolutions Sprint
- Page 1 Sprint Owner’s Manual Assembly Installation Operation • • • Product: Ceiling Fan Trademark: Revolutions Quantity: 1 Piece Electrical Rating: 120V ~ 60Hz Weight ±2 lbs: 10 lbs (4.5 kg) ME006-01 r101614...
- Page 2 - To reduce the risk of fire, electrical shock, or motor damage, use only Hunter Speed Controls. w.4 - To reduce the risk of personal injury, do not bend the blade brackets when installing the blade brackets, balancing the blades, or cleaning the fan.
-
Page 3: Tools And Materials Required
Unpacking the Fan Unpack your fan and check the contents. Do not discard the box. If warranty replacement or repair is ever necessary, the fan should be returned in its original packaging. Remove all parts and hardware. Do not lay the motor housing on its side; the decorative casing may shift. Tools and Materials Required •... -
Page 4: Installing The Mounting Plate
Installing the Mounting Plate 1. Unscrew the four screws on the ceiling canopy to release the mounting plate. (Fig. 1). Secure the mounting plate to a ceiling joist, or equally secure ceiling structure using the two wood fixing screws and washers supplied. The support for the mounting plate must be capable of safely and securely holding the moving weight of the fan (Fig. -
Page 5: Wiring The Fan
Wiring the Fan Ensure electricity is switched off at the main power supply before installing or maintaining this fitting. The ceiling fan can be installed to operate in several different modes: 1. Fan controlled by pull switch, light controlled by pull switch. 2. -
Page 6: Installing The Blades
Installing the Blades 1. Attach the fan blades to the blade holder arms. Three supplied screws, washers, and nuts should be used to securely attach each blade to each blade holder arm (Fig. 5). 2. Attach the other end of the blade holder arm to the fan motor housing using two supplied screws and washers (pre-fitted on the bottom of motor housing), for each blade holder arm (Fig. -
Page 7: Operating The Fan
Operating the Fan 1. Turn power on at the the main fuse box. 2. Turn on the wall switch. Fan Pull Chain Speed Control: Light Pull Chain Control: 1. High 1. Light On 2. Medium 2. Light Off 3. Low 4. -
Page 8: Troubleshooting
Troubleshooting FAN WILL NOT START: 1. Check all fuses or circuit breakers. Replace if missing. 2. Turn off electrical power and check all wire connections to fan and in the wall control. FAN IS NOISY 1. Use of standard light rheostat or continuously variable fan speed wall control will always cause harmonic distortions or a huming noise.