Advertisement
Quick Links
MA1006-EA
• Be sure to keep all user documentation handy for future reference.
• Your watch may differ somewhat from the one shown in the illustration.
5152
Stopwatch second hand
Hour hand
Minute hand
Stopwatch
Day
minute
hand
Second hand
To set the time
1. Pull out the crown to the second click.
• This causes the second hand to stop.
2. Set the hands by rotating the crown.
Move the minute hand four or five minutes past the time you want to set, and then
back it up to the proper setting.
3. Push the crown back in to the normal position to restart timekeeping.
To set the day
1. Pull out the crown to the first click.
2. Set the day by rotating the crown.
3. Push the crown back in to the normal position.
• Avoid setting the day between 9:00 p.m. and 1:00 a.m. (the day display may not
change in the following day).
Using the Stopwatch
The stopwatch lets you measure elapsed time up to 59 minutes, 59 seconds.
To measure times with the stopwatch
Elapsed Time
Start
Stop
To adjust the positions of the stopwatch minute hand and stopwatch
second hand
• This procedure should be performed when the stopwatch minute hand and
stopwatch second hand do not return to the zero positions.
1. Press B to reset the stopwatch.
2. Pull out the crown to the second click.
3. Press A to move the stopwatch second hand forward until it points to the
zero position.
• The stopwatch minute hand is syncronized with the stopwatch second hand.
4. Push the crown back in to its normal position.
• Note that pulling the crown out also stops the timekeeping second hand. After
performing the above procedure, you should also adjust the timekeeping setting.
I For watch with the elapsed time bezel
Rotate the elapsed time bezel to align the
minute hand.
After certain amount of time elapsed, read the graduation on the
elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
• Some water resistant models are equipped with a screw lock
crown.
• With such models, you must unscrew the crown in the direction
noted in the illustration to loosen it before you can pull it out.
Do not pull too forcibly on such crowns.
• Also note that such watches are not water resistant while their
crowns are loosened. Be sure to screw the crowns back in as
far as they will go after making any setting.
Accuracy at normal temperature: ± 20 seconds a month
Stopwatch function: Measuring capacity: 59'59''/Measuring unit: 1 second
Measuring mode: Elapsed time
Battery: One silver oxide battery (Type: SR626SW)
Approximately 2 years on type SR626SW (assuming one stopwatch operation
60 min./day)
Operation Guide 5152/5191
5191
24-hour hand
Stopwatch second hand
Hour hand
24-hour hand
First click
(Day setting)
Second click
(Time setting)
Stopwatch
Day
minute
hand
Crown
(Normal position)
Second hand
Re-start
Stop
mark with the
Specifications
Minute hand
First click
(Day setting)
30
Second click
(Time setting)
Crown
(Normal position)
Clear
Elapsed time bezel
1
Advertisement
