Operation - Makita HR2300 Instruction Manual

Before installing the dust cup, remove the bit from the
tool if installed on the tool. Install the dust cup
(accessory) on the tool so that the
dust cup is aligned with the grooves in the tool.
1
2
010733
To remove the dust cup, pull the chuck cover in the
direction as shown in the figure and with the chuck cover
pulled take the bit out of the tool.
1
010734
And then grab the attachment at the foot of dust cup and
take it out.
1
2
011507
1
2
012895
symbol on the
1. Bit
2. Chuck cover
1. Attachment at
the foot of dust
cup
1. Bellows
2. Attachment
1. Inside periphery
2. Carved side
3. Attachment
4. Cap
5. Groove
3
4
5
1
012896
NOTE:
When installing or removing the dust cup, the cap
•
may come off the dust cup. At that time, proceed as
follows. Remove the bellows from the attachment
and fit the cap from the side shown in the figure with
its carved side facing upward so that the groove in
the cap fits in the inside periphery of the attachment.
Finally, mount the bellows that has been removed.
011505
NOTE:
If you connect a vacuum cleaner to your hammer,
•
cleaner operations can be performed. Dust cap
needs to be removed from the dust cup before the
connection.

OPERATION

Always use the side grip (auxiliary handle) and firmly
hold the tool by both side grip and switch handle during
operations.
Hammer drilling operation
010729
Set the action mode changing knob to the
Position the bit at the desired location for the hole, then
pull the switch trigger. Do not force the tool. Light
pressure gives best results. Keep the tool in position and
prevent it from slipping away from the hole.
9
1. Cap
2. Attachment
2
symbol.