Chapter 5: Hardware Installation; Connecting The Adapter; Figure 5-1: Installing The Adapter Into Your Notebook - Linksys 487023U User Manual

Wireless-G Notebook Adapter

Chapter 5: Hardware Installation

NOTE: You must run the Setup Wizard to install the software
before installing the hardware.

Connecting the Adapter

1. Turn off your notebook PC.
2. Locate an available CardBus slot on your notebook PC.
3. With the connector pin end facing the CardBus slot and the label facing up, slide the Adapter into the CardBus
slot until it locks in place.
4. Restart your notebook PC. The Power LED should light up when the Adapter is installed correctly.
5. Windows will begin copying the driver files to your computer. If Windows asks you for the original Windows
CD-ROM, insert the CD-ROM, and direct Windows to its correct location (e.g., D:\).
The installation of the Wireless-G Notebook Adapter is complete.
If you want to check the link information, search for available wireless networks, or make additional
configuration changes, go to "Chapter 6: Using the Wireless Network Monitor."
Chapter 5: Hardware Installation
Connecting the Adapter

Figure 5-1: Installing the Adapter into your notebook

12