Table of Contents
Advertisement
INSTALLER
Please leave these instructions with the owner.
Read these instructions carefully before installing or trying to operate this vent-free gas heater.
•
Any change to this heater or its controls can be dangerous.
•
Improper installation or use of the heater can cause serious injury or death from fire,
burns, explosion or carbon monoxide poisoning.
•
Do not allow fans to blow directly into the fireplace. Avoid drafts that alter burner flame
patterns.
•
Do not use a blower insert, heat exchanger insert or other accessory, not approved for
use with this heater where applicable.
1. Due to high temperatures, the heater should be
located out of traffic and away from furniture
and draperies.
2. Children and adults should be alerted to the haz-
ard of high surface temperature and should stay
away to avoid burns or clothing ignition.
3. Young children should be carefully supervised
when they are in the same room with the heater
4. Do not place clothing or other flammable mate-
rial near the fireplace when the heater is in use.
5. Any safety screen or guard removed for servic-
ing, must be replaced prior to operating the
heater.
6. Installation and repair should be done by a quali-
fied service person.
7. To prevent malfunction and/or sooting, an
unvented gas heater should be cleaned at least
annually by a professional service person. More
frequent cleaning may be required due to ex-
cessive lint from carpeting, etc. It is imperative
that control compartments, burners and circu-
lating air passageways be kept clean.
8. CARBON MONOXIDE POISONING: Early
signs of carbon monoxide poisoning are similar
to the flu with headaches, dizziness and/or nau-
sea. If you have these signs, obtain fresh air im-
mediately. Have the heater serviced as it may not
be operating properly.
IMPORTANT SAFETY INFORMATION
Please retain these instructions for future reference.
IMPORTANT
9. The installation must conform with local codes or,
in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.l.
10. This unit complies with ANSI Z21.11.2a-1997
Unvented Heaters and also complies with ANSI
Z21.60-1991 Decorative Vented Appliances for
Solid Fuel Burning Fireplaces. State and local
codes may only allow operation of this appliance
in a vented configuration. Check your state or lo-
cal codes. For vented operation, see "Vented In-
structions" in this manual.
11. Do not install the heaters in a bathroom or bed-
room.
12. Correct installation of the ceramic fiber logs,
proper location of the heater an annual cleaning
are necessary to avoid potential problems with
sooting. Sooting, resulting from improper instal-
lation or operation, can settle on surfaces outside
the fireplace. See log placement instructions for
proper installation.
13. Avoid any drafts that alter burner flame patterns.
Do not allow fans to blow directly into fireplace.
Do not place a blower inside burn area of firebox.
Ceiling fans may create drafts that alter burner
flame patterns. Sooting and improper burning will
occur.
14. This is an unvented gas-fired heater. It uses air
(oxygen) from the room in which it is installed.
Provisions for adequate combustion and ventila-
tion air must be provided. Refer to installation
guidelines.
OWNER
3
Hide quick links:
Advertisement
Table of Contents
