Time/Date Display Position - Panasonic AG-TL350B Operating Instructions Manual

7
When the MENU/REC LOCK switch is set to OFF,
the clock automatically starts running from time
and date set.
03- 3-01 3H
03:25:00
For the seconds, "00" is set. Even when the switch
is set to MENU, the time will keep advancing if it
has not been changed.
•
To clear the date and time display, set POSITION under (DISPLAY) on Menu Screen 2 to OFF.
•
Even if the power should fail for a period of up to one week, the date, time and time mode display (internal
timer setting alarm recall) data are stored in the memory (but only if power has been supplied continuously to
the unit for 3 or more days). When the unit has just been purchased or when it has not been used for a long
time, the data is not stored in the memory and the display shown below appears.
[TIME ADJUST]
01- 1-2000 SAT
0:00:00
•
For the date setting, the unit automatically adjusts for leap years.
•
Due to temperature fluctuations and other factors, the clock time may run fast or slow with a monthly error of
up to ±60 seconds. This is not indicative of malfunctioning. Reset the time at regular intervals.
•
When the time is reset to "0:00:00" as described, check the menu settings. If any of the settings are incorrect,
please set them again.

Time/Date Display Position

The position of the date and time displays on the TV monitor changes as shown below when (DISPLAY) on Menu
Screen 2 is changed.
Top left corner Top right corner
1
Set the MENU/REC LOCK switch to MENU to
display to menu screens. Press the page button to
display Menu Screen 2 on the TV monitor.
POSITION : L-UPPER
2
Press the set (+, –) buttons to position the display
as desired.
POSITION : L-BOTTOM
3
Upon completion of the settings, set the MENU/
REC LOCK switch to OFF. The regular screen is
restored, and the date and time appear at the
selected position.
TIME
Flashing
P1
All the internal timer settings are set to OFF,
and the alarm recall display is cleared.
Bottom left corner Bottom right corner
TIME/DATE display position adjustment function
When the unit is in STOP or EJECT mode, the position
of the displayed time/date can be adjusted by pressing
the TRACKING (–) or TRACKING (+) button.
•
Pressing the TRACKING (–) button moves the
position vertically. (Pressing the button 3 times will
return the display to its original position.)
•
Pressing the TRACKING (+) button moves the
position horizontally. (Pressing the button 3 times
will return the display to its original position.)
•
Pressing the (–) and (+) buttons simultaneously will
return the display to its original position (factory
setting).
13
Centre No display