Table of Contents
Advertisement
2.3.4 Timer
To select the timer press mode button (11) until the icon „timer" blinks. By pressing the start/stop button (10) the 10
second count-down of the timer is activated and the green LED blinks once per second. 3 seconds prior to the shot
the frequency of the LED is doubled.
2.3.5 Spooling film to end
To select the spooling function press mode button (11) until the icon „film end" of the display blinks. By pressing the
start/stop button (10) the remaining film and paper edge is spooled onto the spool for exposed film (16).
This function can also be selected when the film is not entirely exposed. The icon „spooling film to end" appears
automatically at the end of film.
2.3.6 Insert new film
The icon „insert new film" appears automatically after completing „spooling film to end".
Open cover release (2) and lift off cover. Swing film pressure plate (18) backwards. Open spool holder for exposed
film (16) and remove exposed film (17). Remove empty film spool (15) and place in spool holder for exposed film
(16). Insert new film in spool holder (14), pull paper edge of film between camera and film pressure plate (18) with
black surface towards exposure slit (19). Attach film to empty spool (16).
Release mechanical-electrical lock (5) and move film counter-clockwise until „Start" mark of non-exposed film (15)
aligns with start mark of spool holder (14). Then swing back film pressure plate (18) until securely fastened.
Put on cover and close cover release (2). If camera in standby mode press start/stop button (10).
To select the film type press mode button (11) until the icon „Film new" blinks (if not displayed automatically). Then
select film type (120 or 220) with selection buttons up (12) or down (13). If the correct film is selected press start/stop
button (10). The camera transports the non-exposed film forward to the exposure slit (19).
The camera is now ready for exposure.
2.3.7 Battery status
The symbol indicates the status of the battery. With a complete power load up to 100 films can be exposed,
depending on speed of operation and temperature. To load the battery connect the camera to a power source with
the universal speed charger unit. The maximum loading time is 4 hours, which is indicated by the blinking of the
green LED of the universal speed charger.
© by Seitz Phototechnik AG, Hauptstr. 14, 8512 Lustdorf, Switzerland
Phone: +41 52 376 3353, Fax: +41 52 376 3305, seitz@roundshot.ch, www.roundshot.ch
Technical changes reserved, Released: 4.2007
Page 8
Advertisement
Table of Contents
