Ntp Authenticate; Ntp Authentication-Key - Zte ZXR10 Command Manual

�
This example describes how to set the ingress unicast sampling
Example
rate on gei_7/23 to 2000 and set the egress multicast sampling
rate to 1000.
ZXR10(config)#interface gei_7/23
ZXR10(config-if)#netflow-sample-rate ingress uincast 2000
ZXR10(config-if)#netflow-sample-rate egress multicast 1000

ntp authenticate

Use this command to enable the NTP authentication function. Dis-
Function
able the authentication with the no command.
Global configuration mode
Command mode
ntp enable
Syntax
no ntp enable
This command is like the switch of the NTP authentication func-
Instruction
tion. The NTP packets will not be checked with key unless this
authentication is enabled.
ntp authentication-key <key number> md5 <key word>
Related
Commands
ntp trusted-key <key number>

ntp authentication-key

Use this command to set the NTP authentication key number and
Function
corresponding key word. Cancel the key with the no command.
Global configuration
Command Mode
ntp authentication-key <key number> md5 <key word>
Syntax
no ntp authentication-key < key number >
Syntax
Description
Instruction Use this command to set key number and the corre-
Instruction
sponding key word. At most 255 check codes can be set.

ntp authenticate

Related
Commands
ntp trusted-key <key number>
Only Ethernet and POS port interfaces support this command.
<key number>
<key word>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 IPV4 Basic Protocols
Key number, in the range of 1~255
Key word
109